Parts of the Lathe


The headstock is to the left as you stand in front of the lathe (if it is not, walk around to the other side before someone notices what you are doing). The headstock is the business end of the lathe, where the power provided by the motor is applied to the wood. Some headstocks are fixed in place, some can rotate through 360-degrees, and some can travel down the length of the lathe. Each of these options allows you to turn larger diameter pieces that would be done ordinarily.


The size of the lathe is determined by two factors; the distance from the center of the spindle to the surface of the bed tells you what the maximum diameter limit is; the distance from the end of the spindle to the inside end of the tailstock tells you what the length of the piece can be.


The spindle is usually driven by pulleys and belts, and the wood is attached to the spindle. The spindle is threaded on the outside in order to accept various attachments, and is usually hollow to also accept various accessories; these accessories are held in place by a specific TAPER (called a MORSE TAPER and is rated by differing sizes, such as #1, #2, #3 or #4).


parts of the wood lathe machine


The bed is the structure upon which all of this is mounted, and can be of timber, round tubes, machined cast iron or steel.


The toolrest is adjustable in height and rotation and can be moved along the length of the bed by loosening the BANJO and retightening it when the desired position is found.


The tailstock is the part of the lathe furthest from the headstock, and is also moveable (and removable). The tailstock has a movable / adjustable part driven by a hand wheel/screw mechanism, and is usually hollow and also fitted with morse taper to accept various accessories.


The motors are usually electric on modern lathes (although several very good lathes use hydraulic motor instead), and can be configured as A/C, D/C, fixed speed, variable speed, reversible, single rotation, electronic braking, and not all motors drive through pulleys: some are direct drive.


- Capt. Jack Wayne

woodturning classes

Related Posts

Project for Bill and Melinda Gates Foundation
Project for Bill and Melinda Gates Foundation
An 18-inch diameter sphere, tolerance +/- .015” that incorporated a vértice axle allowing rotation. Completed it weighed...
Read More
Join us at Bothell Farmers Market!
Join us at Bothell Farmers Market!
What about a well spent family friday? Do you have a father's day present already? Then..  Come and join us THIS FRIDAY...
Read More
Turning project: Architectural columns
Turning project: Architectural columns
I recently accepted a project to turn 3 columns for a house in Seattle that was more than 100-years old.  The surviving ...
Read More


erectile dysfunction pills

erectile strength erectile aid device

plaquenil and eyes

erectile boosting medication which erectile dysfunction drugs work best

canadian weight loss pills

canadian pills pharmacy canadian generic pills

canadian pharmacy cialis without prescription

buy generic cialis, canadian cialis at canadian pharmacy


] Iwozad

Leave a comment